Skip to content
ES App (ES) ↗
Step 2 of 5: Your reducer’s number

Backfocus, demystified · Step 2 of 5

Your reducer’s number (and why it isn’t always 55)

In a sentence: Read up on your reducer and your scope: the manufacturer’s own reducer gives a fixed number; a generic one gives a starting point or a table by focal length.

Where it’s measured from

The manufacturer gives the distance from one specific thread on the reducer to the sensor: almost always the T2 (M42) or the M48, whichever faces the camera. That’s the only measurement that counts, and you’ll find it on the product page or in the manual.

If all you read is “backfocus 55 mm”, check which thread it’s measured from, and whether it’s a single figure or a table.

Three kinds of reducer

Before you go looking for the number, work out which kind of reducer you have (or are about to buy):

What to expect from each kind
KindWhat number it givesWhat to expect
Made by your scope’s manufacturer, for that scopeA fixed one, almost always 55 mmThe easy case: they were designed together. Set the distance and it works
Generic, with a single numberOne number for every scope, often 55 mmA starting point: the result depends on how well two optical designs that weren’t made together happen to match. You may have to experiment
Generic, with a table by focal lengthOne number for each focal-length rangeThe manufacturer has done the work for you: look up your focal length in the table (mine is below)

TipIf you haven’t bought it yet: if you can, buy the reducer from the same manufacturer as your telescope, made for that scope. With a generic one, finding the sweet spot can give you headaches.

My case: same reducer, different number

My reducer is the 2" TS-Optics Photoline 0.79x, a generic one with a table: the distance depends on the focal length of the telescope you put it on. With my 600 mm scope, 58 mm. On a short scope it would ask for as much as 70.

TS-Optics Photoline 0.79x (2" and 3"): distance from the thread to the sensor
Telescope focal lengthBackfocus
Up to 350 mm70 mm
Up to 420 mm65 mm
450–500 mm61 mm
510–600 mm58 mm (my case: 600 mm)
610–700 mm57 mm
710–790 mm56 mm
800 mm and up55 mm

Manufacturer’s figures. On the 2" version it’s measured from the T2 thread; on the 3", from the M48. It’s designed for sensors up to APS-C.

Heads-upThe longer the focal length, the fewer millimeters. If you copy the “55 mm” from a forum and your scope is 400 mm, you’ll be 10 mm short, and you won’t understand why your corners look bad.

Sensor size counts too

Every reducer corrects an image circle of a certain size. The Photoline is meant for sensors up to APS-C: with a full-frame sensor, the corners will look bad even if you nail the distance, because they fall outside what it corrects. Check which sensor size yours was made for before you blame backfocus.