Cooling your telescope down: contents
Guide · 4 steps and a calculator
Cooling your telescope down
How long it really takes to reach air temperature, why it almost never gets there, and what you can do about it.
You carry the telescope out, wait “a while” and get started. The stars never quite tighten up, focus seems to wander, and you blame the seeing. Sometimes it is the seeing. Very often it’s that your mirror is still warm.
What you’ll find here isn’t the usual line (“give it half an hour to acclimate”). These are measured times: from a 2002 Sky & Telescope article whose author put a thermometer on his mirror and published the formula, and from a run of thermocouple measurements on an 11-inch Celestron.
Fair warning: the numbers are worse than you expect. A 200 mm (8-inch) Newtonian that comes out of the house 10 °C warmer than the night air takes two to four hours to settle within 1 °C of it without a fan; a 300 mm (12-inch) one, three to six. But there is a fix, and the good news is that you don’t have to wait for it to finish.
Temperatures on these pages are in degrees Celsius, and where a source measured in Fahrenheit we’ve converted it. A difference of 1 °C is 1.8 °F, so a 10 °C gap is 18 °F.
What you need
- Your mirror’s thickness, if you happen to know it: that’s the variable that rules, more than the aperture.
- A cheap thermometer, if you want to measure your own tube: two readings a while apart are enough.
- A fan, if you have a reflector: it’s the only thing that really changes the problem.
- Somewhere unheated to keep the gear: a garage, a shed or a carport.
The 4 steps
- Step 1 What a warm tube does to your image The air sitting against warm glass moves and distorts the wavefront. There’s a measurement for how much: about four tenths of an arcsecond per degree Celsius of difference.
- Step 2 Does it ever finish? Almost never, and that’s fine The air keeps cooling all night, so a big mirror without a fan stays degrees behind for good: nearly 2 °C if the air falls slowly, close to 5 °C if it falls fast. The point is to shrink the gap, not to close it.
- Step 3 Fans: the one change you can actually see A fan behind the mirror speeds the cooling up by 70%. A fan blowing across the face of the mirror triples it. Both were measured.
- Step 4 Why focus runs away from you by midnight The tube shrinks as it cools and pulls the mirror closer to the camera. It isn’t your focuser slipping: it’s largely the metal.
Careful with the other half: bringing the tube out early is the best thing for cooling and the worst thing for dew. The dew guide explains why, and the last step here shows how to have both.