Skip to content
ES App (ES) ↗

The gear

Reducers and backfocus

In a sentence: A reducer shortens the focal length and widens the field; for the stars to stay round out to the corners, the camera has to sit at exactly the right distance from it: the backfocus.

The essentials

Every reducer or flattener asks for its own exact distance to the sensor, the one its maker gives. If you overshoot or fall short, the stars in the corners come out stretched. The distance is set with spacer rings, and a filter in front of the camera counts too: it lengthens the light path by about a third of its thickness.

Only with a reducer, a flattener or a corrector

With nothing correcting the light between the telescope and the camera there’s no distance to hit: you find focus and that’s that. Backfocus shows up when you add a reducer, a field flattener or a coma corrector, or with scopes that have a built-in flattener.

A distance in millimeters, and not always 55

Every reducer is calculated for one specific distance between its thread and the sensor, and many ask for a different number depending on the focal length of the tube: the TS-Optics Photoline 0.79x asks for 70 mm on a 350 mm scope and 55 mm on an 800 mm one. The camera, the spacers, the wheel and the filter all have to add up to that distance.

A flat filter between the reducer and the sensor lengthens the optical path: add about a third of its thickness (a 2 mm filter, around 0.67 mm).

How to check it

Take a test frame and use software that measures the stars in each corner (ASTAP, or N.I.N.A. with Hocus Focus). If all four corners look alike and worse than the center, it’s the backfocus: change the distance by 1 mm and compare. If only one side is bad, it’s tilt, and moving the distance won’t fix it.

The practical guide, by Fran López, and the spacer calculator.

Backfocus, demystified

Related concepts

← All the guides and concepts