Polar alignment · Step 5 of 7
With N.I.N.A. and Three Point Polar Alignment
In a sentence: Three frames with the mount rotating, the error in altitude and azimuth, and a live measurement while you turn the bolts until you get under an arcminute.
Install and prepare
- In N.I.N.A., open Plugins and, in the available list, install Three Point Polar Alignment. Restart N.I.N.A.
- Check that plate solving works (in Options › Plate Solving, with ASTAP and its D50 or D80 catalog).
- Connect the camera and the mount, and unpark it from its home position.
The three measurements
In the Imaging tab, open the Three Point Polar Alignment panel. Point at a clear patch, ideally near the meridian and not too close to the pole, and press start. The plugin takes a frame, rotates the mount in right ascension (10° by default), takes another, rotates again and takes the third. From the three it works out where the mount’s axis is.
Adjusting in real time
When it finishes, the plugin shows the error in altitude and in azimuth and keeps taking frames without stopping. Turn the azimuth bolts until the azimuth error gets close to zero, and then the altitude ones. Every few seconds the figure updates: green once you drop below the threshold.
- Turn a little at a time and wait for the next measurement before touching anything again.
- Aim for under 1 arcminute in total; at short focal lengths, under 3 is enough.
- When you’re done, tighten the bolts gently and check that the error doesn’t change.
TipIf your mount has no GoTo, or you’d rather move it by hand, the plugin has a manual mode: you turn the right ascension axis yourself between frames.