Skip to content
ES App (ES) ↗
Step 6 of 7: Many short frames

Start with your DSLR · Step 6 of 7

Many short frames: how many, and how to shoot them

In a sentence: You don’t take one photo, you take a hundred or two hundred, which look black on their own but together bring the object out.

Something is there, even if you can’t see it

Each frame, on its own, looks black, as if you’d caught nothing. But something is hiding in there, and adding them up brings it into the light.

On a tripod, the usual thing is 100 to 300 frames. The math is easy: frames = minutes you want to add up × 60 ÷ seconds per frame. To start with, 10 minutes is plenty.

Before you shoot

  • RAW, always: JPEG throws away what you’ll need later.
  • Fixed white balance (daylight).
  • Long exposure noise reduction, off: it doubles the time of every frame.
  • Image review, off: it saves battery.

The programmable shutter release

On the intervalometer you set how many frames, how long each one lasts and the pause between them (1 or 2 s, so the camera can write to the card) and forget about it. The JJC TM series costs about $25: cheap and excellent.

TipIf you’re going past 30 seconds (with a star tracker), put the camera on Bulb (B) and let the release time it.

Recenter every few minutes

Frame by frame, the object drifts off center. Pause every 5 minutes and recenter; the grid on the screen helps. It doesn’t matter that they aren’t centered the same: the stacking software aligns them.

And at the end, a few more

20 or 30 with the cap on (darks): they take out the camera’s own noise. And a few of an evenly lit white surface without touching the focus (flats): they correct dust and dark corners. A white T-shirt with your phone screen behind it will do.

TipTake the camera out half an hour early so it settles at the outside temperature. And if you don’t want to spend a good night shooting darks, do them on another cloudy night at the same temperature, with the same exposure, the same ISO and the same pauses: the sensor will warm up the same way. To stack them, in ASTAP check “Classify by › Dark temperature”: it only pairs each light with the darks at its own temperature.