Skip to content
ES App (ES) ↗
Step 3 of 5: How many watts

Dew · Step 3 of 5

Heater straps: how many watts you really need

In a sentence: Far fewer than you think. The goal isn’t to warm the optics: it’s to make up the few degrees they lose to the sky.

It’s the circumference, not the aperture

The first surprise when you read the catalogs: no manufacturer sizes by aperture. They size by the outside diameter of the tube, because the strap has to wrap around it. Dew-Not spells it out: measure the diameter of the tube, not the aperture of the telescope, and multiply by 3.14.

So to pick a strap you need a tape measure around the tube, not the telescope’s spec sheet. An 80 mm refractor with a fat tube can need the same strap as a 100 mm with a tight one.

What the catalogs give

Side by side, the two catalogs give a rough rule you can use to orient yourself: 2 to 3.5 watts per 100 mm of tube circumference. It isn’t a rule published by anyone, it’s what comes out of dividing their watts by the circumference they correspond to: Dew-Not stays just under 2 on every strip and Kendrick Premier reaches 3.5. Take it as an order of magnitude so you don’t buy blind.

Strap power, from the manufacturer’s catalog
ForKendrick PremierDew-Not
Eyepiece or finder3–4 W2.1–4.2 W
Tube 90 to 130 mm10 W6 W (13" strip)
Tube 140 to 165 mm15 W9.6 W (20.5" strip)
Tube 165 to 200 mm17.5 W—
Tube 200 to 250 mm20 W14 W (30" strip)
Tube 250 to 310 mm25 W17.8 W (38" strip)
Newtonian secondary2.5–9 W—

From the Kendrick (Premier) and Dew-Not catalogs. Dew-Not names its strips by telescope aperture; here they sit in the row their strip length gives them, which is the tube circumference. For a tube around 240 mm, Kendrick gives 20 W and Dew-Not 14: Kendrick itself says its Premier line puts out twice the heat of its FireFly, so there are products solving the same tube with half the power.

How many degrees above ambient

And here’s the most important contradiction in the whole business, worth knowing before you turn the knob up:

  • Kendrick, which sells heaters, recommends keeping the optics 2 to 4 °C (4 to 7 °F) above the air, and says it doesn’t affect seeing.
  • The British Astronomical Association says that with a decent dew shield, a fraction of a degree above the air is enough.
  • An amateur who has tested it reports 1 to 1.5 °C (2 to 3 °F), with no noticeable currents.

Heads-upAll three agree on the substance: the goal isn’t to warm anything, it’s to cancel out the few degrees the glass loses to the sky. If your optics feel warm to the touch, you’ve gone far too far.

Too much power ruins the image

Overheating puts warm air in front of your own optics, and that does the same thing as bad seeing. The BAA warns that overheating “may also cause undesirable local air currents that give the effect of bad atmospheric seeing”, and recommends “very slow, gentle, even heating all around the optics”.

Even Kendrick, which argues its power doesn’t bother anything, warns that running at constant current, with no regulation, can create currents from overheating. One Schmidt-Cassegrain owner puts it better than anyone: with the heater too high, small spikes appear on the stars.

TipIf you’re buying, buy the right size strap and a controller that regulates. A big strap at 40% beats a small one at full blast.

Heads-upNobody has published a measurement of how much overheating degrades seeing: what exists are warnings from an astronomical society, from the manufacturer itself, and accounts from amateurs. They all agree, but there’s no number.

The controller and the battery

Controllers regulate by pulse width: they switch on and off many times a second, and you set the proportion. Kendrick publishes typical duty cycles between 40 and 60%, so a 20 W strap averages about 8 to 12 W, not 20.

Good controllers read the temperature and the dew point and do it for you. If you use an ASIAIR, mind its limits: 3 A per port and 6 A total. ZWO doesn’t publish how much power those outputs deliver, and some people report it doesn’t heat much even with a single strap at maximum.

For the night: add the straps to what your mount and camera draw before you pick a battery. With a 100 to 150 mm refractor, a whole night is about 4 to 7 amp-hours: less than the mount and less than a cooled camera, but enough to leave you short if you haven’t counted it.